Immunity: Induced Voltage
Below you find a short description of EMC PARTNER's product for induced voltage tests.
For our further range of induced voltage tests please take a look at our equipment for
- aircraft electronic tests,
- telecommunication tests
- military tests and
- insulation material tests.
MIG-ITU-K44
Electric power lines and telecommunication lines often occupy parallel routes as a result of the utilisation of joint facilities or the sharing of a common right-of-way. Under abnormal conditions, the power and the telecommunication lines may be come into electrical contact.
The fault induction tester MIG-ITU-K44 generates induced or conducted faults on telecommunication lines.
| Waveforms (Range): | Voltage versus time: 10AxAs curve Frequency: AC 50 or 60 Hz (50 V up to 1690 V) Power: 3.5 VA continuous, 7.5 VA for max. 2s Outputs with overheat protection: 0 Ohm protected by the 16 A fuse 2 x 200 Ohm 2 x 600 Ohm |
 enlarge |
| Control: | Time setting: 0.1 up to 9.9s Voltage measurement: 1 up to 1999 V Current measurement: 0 up to 19.9 A Current waveform BNC output (i) Accuracy 10 V equals 20 A |
|
| Coupling: | Onto telecommunication lines |
|
| Standards: | MIG-ITU-K44 complies with ITU-T K.44 Similar tests are defined in: Bellcore GR1089 Paragraph 4.4 AC Power Fault FCC 68 68.302 Environment simulation |
|
| Required Accessories: | No additional accessories required |
For more information please do not hesitate to contact us.
